![[Pasted image 20240511100900.png]] - Startup - Blue LED: loading - Yellow LED: Ready/standby - If camera is in power on delay mode, hold for five seconds - Modes (M button) - Video 1: Yellow - Video 2: Blue - Photo: Red - Playback: Red, "av cable connected"? - Battery - Rear LED blinks 3 times for full charge, one time when battery is low Generating the text file for config changes: 1. Disconnect the camera from the PC and turn it off. 2. Press and Hold Down the Mode button. 3. Press and Hold Down the Power button until the RED LED blinks 3 times and the camera turns off. This will take about 5 seconds. During the process, the blue and yellow LEDs may blink. 4. Release the Mode and Power buttons 5. The SYSCFG.TXT file showing the camera's current settings should now be in the memory card root folder. Now you can edit the SYSCFG.TXT file as indicated above, and load the new settings back into the camera by using exactly the same method as outlined in steps 1 through 4, above. Once completed, the "SYSCFG.TXT" file will be automatically deleted from the card's root folder ![[Pasted image 20240511102024.png]]